LOCTITE® 603

Features and Benefits

Retaining Compound - high strength. Ideal for bearings. For use on close-fitting cylindrical parts. High oil tolerance.
LOCTITE® 603 is a high-strength retaining compound. Designed for the bonding of cylindrical fitting parts, especially for sintered bearings and also where consistently clean surfaces cannot be assured. The product cures when confined in the absence of air between close-fitting metal surfaces and prevents loosening and leakage due to shock and vibration. It has a high oil tolerance.
  • High-strength retaining compound
  • Especially suitable for sintered bearings
  • High oil tolerance
Read More

Documents and Downloads

Safety Data Sheets and RoHs
LOCTITE® 603, 250 ml Bottle 142443 en-GB
IDH: 142443
EAN: 5010266168975

Size Case: Bottle

Quantity: 10.0/case

LOCTITE® 603, 10 ml Bottle 1967549 en-GB
IDH: 1967549
EAN: 4058093009376

Size Case: Bottle

Quantity: 12.0/case

No documents found

Technical Information

Agency approvals / certificates / specifications NSF, WRAS
Colour Green
Fixture time 10.0 min.
Gap fill 0.15 mm
Key characteristics Oil Tolerant, Viscosity: Low Viscosity
Operating temperature -55.0 - 150.0 °C (-65.0 - 300.0 °F )
Recommended for use with Metal: Steel
Shear strength, Steel 26.0 N/mm² (3770.0 psi )
Viscosity 125.0 mPa·s (cP)

How to

Step by Step Guide

1. Preparation - Cleaning

Use LOCTITE® 7200 for easier removal of residues in case of old retaining adhesive. It is recommended to use LOCTITE® 7063 to degrease and clean surfaces prior to applying the adhesive. For gaps larger than 0.5mm or worn out shafts, bearing seats or keyways, use LOCTITE® metal-filled compounds.

2. Preparation - Activation

If cure speed is too slow due to passive metals or low temperature (below 5°C), use activator LOCTITE® 7240 or LOCTITE® 7649 (see cure speed vs activator graph in the TDS).

3. Application - For Slip Fitted Assemblies

Apply adhesive around the leading edge of the male component and the inside of the female component and use a rotating motion during assembly to ensure good coverage.

4. Application - For Press Fitted Assemblies

Apply adhesive thoroughly to both bond surfaces and assemble at high press on rates.

5. Application - For Shrink Fitted Assemblies

Apply the adhesive onto the shaft; heat the collar to create enough clearance for free assembly.

6. Equipment

For manual assembly of adhesive, the use of a peristaltic hand pump is recommended to ensure a consistent application volume. For semi-automatic or fully-automated dispensing options, contact our technical service team for advice.

7. Disassembly

Apply localised heat to approximately 250°C; disassemble while hot. For corroded or seized parts, use LOCTITE® LB 8040 Freeze and Release.

Where to Buy

Buy Online

LOCTITE® 603
Retaining Compound - high strength. Ideal for bearings. For use on close-fitting cylindrical parts. High oil tolerance.

    Buy Nearby

    Use our distributor locator to find your nearest store.

    * Contact the distributor to confirm that the selected product is in stock.

    Go To distributor locator

    Frequently Asked Questions

    How to use